This command is useful when you need to see detailed statistics on an interface basis. Increase Console level Output debug kernel console-level 8 If you want to see FAN Speed or temperature information, you can use the debug hardware features.
To clean it up, you can run the above command.įAN Speed Check / Temperature Check debug hardware In some rare conditions it could be that the Flash is full (100%). configure terminalįor more information on the subject, you may check the full CLI reference guide of the device you are using via: CLI Documentation Fullįlash is full (100% Flash Usage) debug system _disk-cleanup Some of them need to be executed via the following mode before the command will be accepted. Note: All CLI commands need to be entered by "SSH". (commands are available from 4.33 - WK30 or later) can be found here: This article gives you an overview of helpful and amazing CLI commands, available but not yet integrated within the web interface.